Blow Heaters

Heat-Flo ™ Blow Heaters can only be used with an LPG cylinder and can not be converted for use with Natural Gas.

No. Each heater has a set gas input, so there is only 1 flame. If more or less heat is required, we have 4 different sizes available with different gas consumptions.

Each heater comes with a hose and regulator to connect to a 45kg cylinder. We do not provide any alternatives such as type 27, bayonet, or longer hoses.

Our blow heaters have been tested and approved to the relevant AS/NZ standards using a 45kg cylinder. Due to compliance factors in place, we would request you follow the instructions mentioned in the manual.

Heat-Flo™ Tile Heaters with more tiles generate more heat and therefore use more gas. Below are estimations on how long each heater runs for:

No. It uses a POL or type 27 connection to an LPG cylinder, not a bayonet connection. This product is designed for LPG and should not be converted.  

No. Each heater has a set gas input and there is only 1 flame. Get a smaller or larger heater size for smaller or larger flame. 

We do not have official noise data. They are designed for industrial settings, so noise was not a design factor, therefore they are relatively loud.

2.5m from heater outlet. 1.25m from the tops, sides and inlet. Never operate on elevated structures such as platforms or scaffolds.

To select the right heater, consider the volume of the room that you require heating. The larger the room, the higher KW output required to heat the room.

As per the instruction manual, the inlet gas connection for the blow heater has size ¼” G LH thread. As per our specifications, these blow heaters are designed to be directly connected to the gas cylinder and so are provided with the corresponding hose connection. Unfortunately, we don’t have a hose which has the required thread to a bayonet connection.